The Extreme S3 SSD drive from Teamgroup uses the SATA 3 interface and a SANForce controller chip inside. The Read/write speed is around 600 Gb/s. The Ferrari looking drive called the TP123, uses USB 3.0 interface. the card reader for CF and other formats also uses USB 3.0 interface.
Milton introduces the USB 3.0 expresshost which fits snugly into your notebook and can fit without an edge sticking out. The Expresshost supports CF, 50 pin 1.8″drives and Ziff drives. In addition, using the adapter and a cable you can connect your 2.5″drives as well.
This all round solution makes downloading data a snap.
See more at http://www.photofast.tw
Card 1: PCI-Express- Use 8x CF cards in RAID configuration to create a SSD.
Card 2: PCI-Express – Use 2x CF cards with already installed onboard SSD memory to increase the SSD as needed.
Card 3: Module Open – Can replace each memory module with your own flash memory (OEM customers take note)
Card 4: XG Monster – 3.5″ SATA SSD, running RAID 5 (speed-270 Mb/Sec)
CF card CR-7100/7200 : SD and Micro SD adapter
SD cards : MS and MS2 in RAID
E-SATA Card, 128GB -Speed, 120 MB/sec
Express card: Very fast access times (about 0.1 ms)
V3, V4S and V5 next generation SSD using RAID zero to implement extremely fast read write speeds.
The V2 Card uses 800MHz Intel 81348 XScale I/O chipset, using 256MB ECC DDRII & 64 x4 SDRAM running in RAID 6, with increased speeds across the board.
MSRP – 128GB version = US$1000.